Bookings

You must use equipment within your booked time.

If you miss three bookings, you will lose Makerspace access for one month.

Contact the Makerspace if you cannot attend your booking.

For overnight printing, you must come to the Makerspace one hour before closing to set up your print.

Equipment used outside the Makerspace must be picked up during Makerspace hours.

Return all equipment on time. Late returns are charged $0.50 per hour. Lost, stolen, or damaged items will be charged at full replacement cost.

Fees

3D printing costs $0.50 per 15 minutes for non-academic or non-entrepreneurial use. The first 10 hours are free.

Print-and-cut stickers cost $2.50 per sheet (8.5 x 11), with a limit of three sheets per booking.

Buttons cost $0.25 each. Printing a template in the Makerspace costs an additional $0.25 per page.

Payment is by debit or credit card only.

You have 10 hours of free recreational 3D printing.

The Makerspace uses PLA filament only. You cannot use your own materials.

You must get staff approval for prints that exceed your booked time.

You must not create weapons, explosives, or materials that are dangerous or offensive.

The Makerspace can provide support for faculty who wish to integrate making into their course instruction. Contact the Makerspace and your liaision librarian to discuss further.

Campus groups can work with the Makerspace for events. Fees may apply depending on the materials used.

Community members can contact the UTSC Office of Community Partnerships & Engagement to discuss potential collaborations.

You must follow Canadian copyright laws when reproducing material.

Check for copyright restrictions and look for Creative Commons licences or terms of use before using materials.